Cisco Catalyst 3550 Command Reference Manual page 248

setup
Examples
This is an example of output from the setup command:
Switch# setup
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system.
Would you like to enter basic management setup? [yes/no]: yes
Configuring global parameters:
Enter host name [Switch]:host-name
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: enable-secret-password
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: enable-password
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: terminal-password
Configure SNMP Network Management? [no]: yes
Community string [public]:
Current interface summary
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
Vlan1
GigabitEthernet0/1
GigabitEthernet0/2
GigabitEthernet0/3
GigabitEthernet0/4
GigabitEthernet0/5
Catalyst 3550 Multilayer Switch Command Reference
2-222
IP-Address OK? Method Status
172.20.135.202 YES NVRAM
unassigned YES unset
unassigned YES unset
unassigned YES unset
unassigned YES unset
unassigned YES NVRAM
Chapter 2 Cisco IOS Commands
Protocol
up up
up up
up down
administratively down down
up down
up down
78-11195-09