Siemens Brodersen MC55 AT Command Manual page 429

• Alarm settings on ASC0 / ASC1 and different Multiplexer channels (see AT+CMUX):
- On each interface an individual
means an alarm
<time>
faces. Therefore, the total number of alarm events returned by the read command AT+CALA? will always
be <n>=0, no matter whether different text messages are stored.
- When the scheduled alarm occurs, the ME sends the URC only on the interface where the most recent
alarm setting was made. The alarm time will be reset to "00/01/01,00:00:00" on all interfaces.
Examples
EXAMPLE 1
You may want to configure a reminder message for July 31, 2005, at 9.30h, including the message "Good
Morning".
AT+CALA="05/07/31,09:30:00",0,0,"Good Morning"
OK
Do not switch off the GSM engine.When the alarm occurs the ME returns the following URC:
+CALA: Good Morning
EXAMPLE 2
To set a fresh alarm using the same message as in Example 1, simply enter date and time. <n>, <type>,
<text>, <tlength>
AT+CALA="05/07/31,08:50:00"
OK
When the alarm is executed the URC comes with the same message:
+CALA: Good Morning
EXAMPLE 3
To enable the ME to wake up into Alarm mode, e.g. on July 20, 2005, at 8.30h, enter
AT+CALA="05/07/20,08:30:00"
OK
Next, power down the ME:
AT^SMSO
^SMSO: MS OFF
OK
^SHUTDOWN
When the alarm is executed the ME wakes up to Alarm mode and displays a URC. If available, this line is
followed by the individual
appears.
"+CALA"
+CALA: Good Morning
MC55_ATC_V04.00
Confidential / Released
message can be stored, but only one time setting applies. This
<text>
set on one of the interfaces overwrites the time setting on all remaining inter-
can be omitted:
most recently saved. If no individual message was saved only the first line
<text>
Page 429 of 475 3/17/06