Siemens Brodersen MC55 AT Command Manual page 240

Syntax
Test Command
AT^SISO=?
Response(s)
OK
Read Command
AT^SISO?
Response(s)
^SISO: <srvProfileId>, <srvParmTag>value "srvType" [, <srvState>, <socketState>,
<rxCount>, <txCount>, <locAddr>, <remAddr>]
[^SISO: ...]
OK
Write Command
AT^SISO=<srvProfileId>
Response(s)
OK
ERROR
+CME ERROR: <err>
Parameter Description
(num)
<srvProfileId>
0 ... 9 specified with AT^SISS.
<srvProfileId>
(num)
<srvState>
Internet service state.
Please note, that the state of an Internet service may influence the state of the serial DCD line. For details see
description of value 2 for parameter
2
3
MC55_ATC_V04.00
Confidential / Released
PIN
§
of command AT&C.
<value>
Allocated
Service profile resources are allocated, i.e. at least the service type has been
set (parameter <srvParmTag>, value "srvType" of AT^SISS). The service is
not opened, but ready for configuration.
Connecting
State after opening a service with
established.
If connection setup is successful the service proceeds to the state "4" (Up) and
one of the URCs "^SISW" and "^SISR" may follow. If connection setup is not
successful, the "^SIS" URC may appear and the service enters
6 (Down).
In the case of FTP, <srvState>=3 means that the command channel is being
established.
If the service profile is configured as Socket listener, then the listener always
stays at <srvState>=3 and <socketState>=3 (LISTENER), while the
and
<srvState> <socketState>
file may change. See examples in Section 10.5.1.
Page 240 of 475
ASC0 ASC1 MUX1 MUX2
% % % %
where the connection is being
AT^SISO
of the dynamically assigned service pro-
MUX3 Charge Last
% ! ! !
<srvState>
3/17/06