Table of Contents
Advertisement
Unsolicited Result Code
Unsolicited Call Status information
if the list of current calls is empty:
^SLCC:
if one or more calls are currently in the list:
^SLCC: <idx>, <dir>, <stat>, <mode>, <mpty>,
<number>, <type>[, <alpha>]]
[^SLCC: <idx>, <dir>, <stat>, <mode>, <mpty>,
<number>, <type>[, <alpha>]]]
[... ]
^SLCC:
URC "^SLCC" displays the list of current calls as displayed with the execute command AT^SLCC. The list is dis-
played in the state it has at the time of display, not in the state it had when the signal was generated.
The URC's occurrence indicates call status changes for any of the calls in the list of current calls.
Please refer to
Call Status Information
this URC.
Event reporting can be enabled separately for each interface. Interface settings are saved with
displayed with AT&V. Additionally, The URC presentation mode for the interface must be configured with
AT+CMER.
Depending on the value of
command
and AT+CMER)
AT^SLCC
•
when a state transition ends in state "active" or in state "unknown" (if
•
when any state transition (including transitions beginning or ending in state "unknown") occurs in the list of
active calls, or when a traffic channel is established (if
If multiple displays of identical list configurations occur, this happens because of short intermediate states of the
list, that have already been overridden by new transitions and states. Thus, it is guaranteed that the configuration
displayed is always the current configuration at the time of the last display.
The list of active calls displayed with this URC will always be terminated with an empty line preceded by prefix
''^SLCC: '', in order to indicate the end of the list.
Command Description
The read command returns an indication whether event reporting is active for the current interface.
The exec command returns a list of current calls of ME. If command is successful, but no calls are available, no
information response is sent to TE.
Use the write command to activate or deactivate event reporting for URC "^SLCC". Event reporting can be
enabled separately for each interface. Interface settings are saved with
Parameter Description
(num)
<idx>
call identification number as described in GSM02.30 subclause 4.5.5.1; this number can be used in
command operations
(num)(&W)(&V)
<n>
(&F)
[0]
1
(num)
<dir>
0
1
MC55_ATC_V04.00
Confidential / Released
and
setting <sucs>, Indicator "^SLCC" will be issued (if configured with write
AT^SCFG
presentation of URC "^SLCC" disabled
presentation of URC "^SLCC" enabled
mobile originated call (MOC)
mobile terminated call (MTC)
Page 150 of 475
<traffic channel
<traffic channel
for further information about the configuration of
AT^SCFG
AT^SCFG
setting <sucs>="verbose").
AT^SCFG
AT&W
assigned>[,
assigned>[,
and can be
AT&W
setting <sucs>="restricted")
and can be displayed with AT&V.
AT+CHLD
3/17/06
Advertisement
Table of Contents
