Siemens Brodersen MC55 AT Command Manual page 359

(num)
<bm>
Broadcast Type Messages:
0
1
Notes
• If CSMS mode is switched from Phase 2+ to Phase 2 and one or more
specific a '+CMS ERROR: unknown error' will appear. It is recommended to switch the
to Phase 2 specific values before entering Phase 2.
• Phase 2+ (<service>=1) must be set before the following features can be used:
- Configuring procedures for indicating received short messages with the
<mt>=3 and <ds>=1.
- Acknowledging incoming short messages with AT+CNMA.
- Receiving Status Reports and acknowledging them with AT+CNMA.
MC55_ATC_V04.00
Confidential / Released
Type not supported
Type supported
Page 359 of 475
Parameter are Phase 2+
AT+CNMI
Parameters
AT+CNMI
parameters <mt>=2 or
AT+CNMI
3/17/06