Table of Contents
Advertisement
(num)
<type>
type of address octect
145
129
(str)
<alpha>
Alphanumeric representation of
should be the one selected with command
The maximum displayed length of
first 15 characters will be displayed. To indicate an overflow, a special character will be used as the 16th char-
acter. This will be a space if the character set selected with
'UCS2'.
Due to time constraints on the necessary evaluation of the phonebook, this parameter may show a default value
during early call phases (e.g. for <stat>= ''dialing'', ''incoming'' or ''alerting''), even if a phonebook entry is
present for the number concerned.
Notes
•
Teleservices other than voice, data, fax are not fully supported by ME. They are used only in connection with
the handling for AT+CSNS, and may therefore occur in parameter
•
If a URC "^SLCC" in verbose mode (see AT^SCFG) has been buffered while the interface was in dedicated
mode (depending on the settings of
as a separate URC after the interface returns to idle mode.
However, the output will deliver the list of current calls in the "current" state (at the time when the output is
generated), possibly leading to multiple displays of identical list configurations.
•
Some parameters of AT command AT+CHLD, as well as some situations where the call status in the network
changes very quickly (e.g. the transition between <stat>= ''unknown'', ''dialing'' and ''alerting'' for a call to a
reachable subscriber within the registered network) may lead to quasi-simultaneous changes to the states of
one or several calls in the list, possibly leading to multiple displays of identical list configurations.
•
If multiple displays of identical list configurations occur, this happens because of intermediate states of the
list, that have already been overridden by new transitions and states. Thus, it is guaranteed that the configu-
ration displayed in such cases is the current configuration at the time of the last display.
•
It is adviseable to receive URC "^SLCC" on an interface that is not used for call initiation, if verbose output is
configured. If only voice calls are expected, a setting of AT^SM20= 0 may be used alternatively in order to
keep the call from blocking the interface.
Examples
EXAMPLE 1
^SYSSTART
at+cpin=9999
OK
+CREG: 2
+CREG: 1,''0145'',''0016''
at^sm20=0
OK
atd''1234567'';
OK
MC55_ATC_V04.00
Confidential / Released
dialing string
<number>
otherwise
corresponding to the entry found in phonebook; used character set
<number>
(Select TE Character Set).
AT+CSCS
is 16 characters. If
<alpha>
parameter <bfr>), each buffered event indicator will be output
AT+CMER
Page 152 of 475
includes international access code character '+'
has more than 16 characters, only the
<alpha>
is 'GSM', or 'E400' if the character set is
AT+CSCS
for mobile terminated calls.
<mode>
We are now registered
command ''ATD'' for an outgoing voice call will termi-
nate immediately with response ''OK''
We start a voice call.
''OK'' response is issued immediately because of set-
ting ''^SM20=0''
3/17/06
Advertisement
Table of Contents
