Parameter Description
(num)
<type>
Type of ring tone. You have a choice of 7 different ring tones and melodies. All will be played from the audio
output selected with the
0
1
2
(D)
3
4
5
6
7
(num)
<volume>
Volume of ring tone, varies from low to high
(D)
0
1
2
3
4
5
6
7
(num)
<status>
Status of test ringing. Indicates whether or not a melody is currently being played back for testing
0
1
Notes
•
Before first using ring tones note that the following settings apply:
We have chosen to let you decide your own preferences when you start using ring tones. Therefore, factory
setting is AT^SRTC=3,0,0 (ring tones are muted). To activate ring tones for the very first time, first enter the
write command and simply change the volume. After applying a firmware update the volume and type
selected before the firmware update will be preserved.
•
The test ringing signal cannot be activated while an MTC is ringing (ERROR).
•
If an MTC arrives during test playback, test ringing will be deactivated and "normal" ringing reactivated
(RING). Likewise, an MOC will also stop test ringing.
•
If no optional parameter is entered, the old value will be kept.
MC55_ATC_V04.00
Confidential / Released
command. <type>=0 is only intended for muting.
AT^SNFS
Mutes the currently played tone immediately.
Sequence 1
Sequence 2
Sequence 3
Sequence 4
Sequence 5
Sequence 6
Sequence 7
Mute
Very low
Identical with 1
Low
Identical with 3
Middle
Identical with 5
High
Switched off
Switched on
Page 425 of 475
3/17/06