...................................................................................................................................................................................................................................

Overview

This test checks whether the management communication channel via the DCC bytes is

operational on the link.

Estimated duration

5 minutes.

Test setup

Establish a test setup similar to

Be sure that the MS DCC on the line ports of both nodes is set to

1643 AM/AMS node this is default.

(Go to menu: Management, Overlay Comms Network, DCC, select

Figure 8-1 Remote login test

Remark

Procedure

Proceed as follows to test the DCC communication:

...................................................................................................................................................................................................

With the ITM-CIT login to node A.

...................................................................................................................................................................................................

Check whether you can see the remote node B on the DCC Neighbor list.

(Go to menu: File, NE Login, DCC Neighbors List, click OK.)

...................................................................................................................................................................................................

Do a remote login to node B, and watch the name of node B appear on top of the

ITM-CIT window. (Select

8-4

: Node A is expected to be a 1643 AM/AMS node.

LPx.1

Alcatel-Lucent - Proprietary

See notice on first page

Figure 8-1, "Remote login test" (p. 8-4)

, click Login, OK)

. For the

Enabled

, EDIT)