Alcatel-Lucent 1643 AMS Installation Manual page 213

Stand-alone test procedures
Conclusion: If the Fault LED is OFF, then the option card is accepted and the
option card software is correctly loaded. If the Link LED comes on and the alarms
are reported, then the option card is correctly installed.
...................................................................................................................................................................................................
If a DDF is applicable, then proceed with
5
proceed with
...................................................................................................................................................................................................
Connect LAN2.1 to LAN2.3.
6
...................................................................................................................................................................................................
Check on the alarm list, and verify that the requirements mentioned in the table below
7
are met.
Result:
Link LEDs of related LAN ports:
Alarms reported on the ITM-CIT:
Conclusion: Results of
LAN2.2, and LAN2.3 is correct.
...................................................................................................................................................................................................
Connect LAN2.1 to the next LAN port.
8
...................................................................................................................................................................................................
Check on the alarm list, and verify that the requirements mentioned in the table below
9
are met.
Result:
Link LEDs of related LAN ports:
Alarms reported on the ITM-CIT:
...................................................................................................................................................................................................
Repeat
10
...................................................................................................................................................................................................
Disconnect the LAN cable from the LAN ports. Wait until all LANcNES alarms have
11
cleared.
...................................................................................................................................................................................................
Verify that the requirements mentioned in the table below are met.
12
...................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Step 11.
Step 4
Step 8 and Step 9 for all other LAN ports.
Alcatel-Lucent - Proprietary
See notice on first page
Step 6. If no DDF is applicable, then
Requirements
On (green)
"LANcNES" reported on LAN2.1 and
LAN2.3
and Step 7 prove that the DDF labeling of LAN2.1,
Requirements
On (green)
"LANcNES" reported on related LAN
X4IP, X8PL, and X5IP option card test
7-23