Stand-alone test procedures
Fault:
PDH analyzer:
Alarms reported on the ITM-CIT:
...................................................................................................................................................................................................
Disconnect the incoming signal from the port in use.
9
E
N D
...................................................................................................................................................................................................
Cleaning up
The following must be performed to clean up the system:
• Reset the Alarm Reporting/Severity of the STM1cNES (STM-1 Not Expected Input
Signal) alarm to default (Not Reported).
• Delete all cross-connections.
...................................................................................................................................................................................................................................
7-18
O F
S T E P S
Alcatel-Lucent - Proprietary
Requirements
Off
No errors
"STM1cNES" (STM-1 Not Expected Input
Signal) on TP2.1 and TP2.2
See notice on first page
Optical STM-1 option card test
365-312-802R7.2
Issue 4, June 2007