Alcatel-Lucent 1643 AMS Installation Manual page 187

ITM-CIT installation and NE provisioning
Result:
Provisioned NE Components appears again.
...................................................................................................................................................................................................
If creating a node, then click
6
Result:
Node Creation - Provision Slots) disappears.
E
N D
...................................................................................................................................................................................................
Parameters
Slot
The slot position is given here.
Expected unit
The type of unit provisioned in the listed slot is shown.
Slot state
Displays the status of the listed slot. The different slot states are described in the table
below.
Slot state
Assigned
Unassigned
Auto
Operation
When assigning units, an operation must be chosen. The choices are described in the
table below.
Operation
Assigned
Unassigned
Auto
....................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
The desired operation for this slot is performed, and the window
The window Provisioned NE Components (or in the case of node creation,
O F S T E P S
Description
Slot is assigned
Slot is unassigned
Slot is provisioned but waiting for unit. Once the provisioned
unit is present, the slot state will automatically change to
Assigned.
Description
Assigns the unit to the slot.
The slot is configured to be empty. The NE will not expect any
unit to be present in this slot.
Automatically assigns the unit to the slot once the NE
establishes the presence of a unit of the correct type. Until this
time, the slot acts as Unassigned.
Alcatel-Lucent - Proprietary
Finish
. Otherwise, click
See notice on first page
Slot provisioning
Close
.
6-21