Selecting A Network Type; Entering Your M Msi N Umber; Switching On The Ais Receiver O N; Entering Your M Msi N Umber O N - Raymarine RAY90 Installation & Operating Instruction

5.8 S witching on the AIS
receiver
If y our r adio includes a built-in AIS receiver t hen it c an
be enabled and disabled as follows:
From the Main menu:
1. Select Set-up.
2. Select AIS.
3. Select On to switch the receiver o n, o r s elect
switch the receiver o ff .
Getting started
81377-1-en_US_PRINT.pdf 39

5.9 Selecting a network type

When connecting your r adio to other d evices it i s
important t o ensure you select t he network connection
and type that y ou want d ata to be transmitted over.
From the Main menu:
1. Select Set-up.
2. Select Network output .
Off to
The following network types are available:
• NMEA 2000 (default)
• 0183 High speed
• 0183 Std speed
3. Select t he network type relevant t o the devices
connected to your r adio . If y our r adio is not
connected to any other d evices any option can be
selected.
Selecting 0183 Std speed
receiver, where applicable.
The Network output setting determines the baud rate
of t he NMEA 0183 input:
Network output s etting
NMEA 2000
NMEA 0183 High Speed
NMEA 0183 S tandard
Speed
5.10 Entering your M MSI
number
T o program your r adio with your M MSI n umber f ollow
the steps below.
From the Set-up menu: (
1. Select
2. Select
will d isable the built-in AIS
The MMSI r equired message will b e displayed if n o
MMSI n umber h as been set.
3. Select
4. Use the
NMEA 0183 input b aud
numbers and press
rate
move to the ne
Standard speed (4,800)
Y ou should only enter t he unique 9 digit M MSI
number p rovided by your l icensing authority.
High speed (38,400)
MMSI n umbers starting with a '0' a re only used for
groups and coast s tations. If y ou enter a '0' a s the
Standard speed (4,800)
first d igit t he radio will a ssume you are entering a
coast s tation MMSI a nd automatically assign a '0' a s
the second digit; t his is to ensure a group MMSI i s
not e ntered as the radio's unique MMSI.
5. Press the
have already entered.
6. Press and hold the
Move cursor back and forward through the digits.
Menu > Set-up )
DSC set-up .
MMSI.
Yes .
Rotary knob to cycle through the available
OK to confirm each number a nd
xt d igit.
Back button at a ny time to edit d igits you
OK button to display options to
12/21/2017 9:05:37 PM
39