Chapter 1 Important I Nformation - Raymarine RAY90 Installation & Operating Instruction

Chapter 1 : Important
information
Certified Installation
Raymarine recommends certified installation by a
Raymarine approved installer. A certified installation
qualifies for e nhanced product w arranty benefits.
Contact y our R aymarine dealer f or f urther d etails, a nd
refer t o the separate warranty document p acked with
your p roduct.
Warning: Product i nstallation
and operation
• This product m ust b e installed and
operated in accordance with the
instructions provided. Failure to do so
could result i n personal i njury
to your v essel and/or p oor p roduct
performance.
• Raymarine recommends certified
installation by a Raymarine approved
installer. A certified installation qualifies
for e nhanced product w arranty benefits.
Contact y our R aymarine dealer f or f urther
details, a nd refer to the separate warranty
document p acked with your p roduct.
Warning: Potential i gnition
source
This product i s NO T approved for u se in
hazardous/flammable atmospheres. Do
NOT install in a hazardous/flammable
atmosphere (such as in an engine room or
near f uel t anks).
Important i nformation
81377-1-en_US_PRINT.pdf 9
Warning: 12 Volt d c only
This product m ust o nly be connected to a
12 volt d c
Warning: Chassis grounding
Do NO T ground this product u sing the
chassis ground terminal.
Grounding this product t o a vessel's RF
ground may cause galvanic corrosion.
Warning: Positive ground
systems
Do not c onnect t his unit t o a system which
has positive grounding.
, damage Warning: Switch off p ower
supply
Ensure the vessel'
switched OFF before starting to install t his
product. Do NOT connect o r d isconnect
equipment w ith the power s witched on,
unless instructed in this document.
FCC
Warning: FCC Warning (Part
15.21)
Changes or m odifications to this equipment
not e xpressly approved in writing by
Raymarine Incorporated could violate
compliance with FCC rules and void the
user's authority to operate the equipment.
power s ource .
This device may not c ause harmful i nterference.
s p ower s upply is
Reorient o r r elocate the receiving antenna.
3. Connect t he equipment i nto an outlet o n a
Compliance S tatement ( Part 1 5.19)
This device complies with Part 1 5 of t he FCC Rules.
Operation is subject t o the following two conditions:
1.
2. This device must a ccept a ny interference received,
including interference that m ay cause undesired
operation.
FCC Interference Statement ( Part
15.105 (b))
This equipment h as been tested and found to comply
with the limits for a Class B digital d evice, p ursuant t o
Part 1 5 of t he FCC Rules.
These limits are designed to provide reasonable
protection against h armful i nterference in a residential
installation. This equipment g enerates, u ses, a nd can
radiate radio frequency energy and, i f n ot i nstalled and
used in accordance with the instructions, m ay cause
harmful i nterference to radio communications. However,
there is no guarantee that i nterference will n ot o ccur i n
a particular i nstallation. If t his equipment d oes cause
harmful i nterference to radio or t elevision reception,
which can be determined by turning the equipment o ff
and on, t he user i s encouraged to try to correct t he
interference by one of t he following measures:
1.
2. Increase the separation between the equipment
and receiver.
circuit d ifferent f rom that t o which the receiver i s
connected.
4. Consult t he dealer o r a n experienced radio / T V
technician for h elp.
Innovation, Science and
Economic Development Canada
This d evice complies w ith ISEDC License-exempt.
RSS standard(s).
Operation is subject t o the following two conditions:
12/21/2017 9:05:36 PM
9