Selecting A Network Type; Entering Your Mmsi Number; Enabling And Disabling Atis Mode - Raymarine Ray50 Mounting And Getting Started

Selecting a network type

When connecting your radio to other devices it is
important to ensure you select the network connection
and type that you want data to be transmitted over.
From the Main menu:
1. Select Set-up.
2. Select Network type.
The following network types are available:
• NMEA 2000 (default) — uses the SeaTalk
connection to transmit data to other devices.
• 0183 High speed — uses the NMEA 0183
connection with 38400 baud rate
• 0183 Std speed — uses the NMEA 0183
connection with 4800 baud rate.
3. Select the network type relevant to the devices
connected to your radio. If your radio is not
connected to any other devices any option can be
selected.
Selecting 0183 Std speed will disable the internal
AIS receiver on a Ray70.

Entering your MMSI number

To program your radio with your MMSI number follow
the steps below.
1
2
From the Main menu:
1. Select Set-up.
2. Select DSC set-up.
3. Select MMSI.
(Not set) will be displayed if no MMSI number has
been set.
4. Use the Rotary knob to cycle through the available
numbers and press OK to confirm each number and
move to the next digit.
ng®
You should only enter the unique 9 digit MMSI
number provided by your licensing authority.
MMSI numbers starting with a '0' are only used for
groups and coast stations. If you enter a '0' as the
first digit the radio will assume you are entering a
coast station MMSI and automatically assign a '0' as
the second digit; this is to ensure a group MMSI is
not entered as the radio's unique MMSI.
5. Press the Back button at any time to edit digits you
have already entered.
6. Press and hold the OK button to display options to
Move cursor back and forward through the digits.
7. When the final digit is confirmed select DONE.
1 2 3
3
8. The MMSI is displayed onscreen, check that it is
4
correct, then:
i. Select Yes – Save, or
ii. if the number entered is not correct select No
– Retry.
Dxxxxx-1
4 5 6 7 8 9
Done
Caution: MMSI and ATIS ID
entry
You can only enter the MMSI number and
ATIS ID once!
If you store an incorrect MMSI number or
ATIS ID in your product, it will have to be
reset by an authorized Raymarine
Enabling and disabling ATIS
mode
ATIS is a European system used on some inland
waterways. ATIS must be enabled and a unique ATIS
ID entered in order to use ATIS mode.
From the Main menu.
1. Select Set-up.
2. Select ATIS set-up.
3. Select ATIS.
4. Select On to enable ATIS mode or Off to disable
ATIS mode.
With ATIS mode enabled the radio's region will be
fixed to the INT (international) frequency band and
the following functions are disabled:
• DSC functions
• Watch Mode
• Scan Mode
• High/low power is restricted on certain channels
Once ATIS has been enabled an ATIS ID must be
entered.
® dealer.
19