Dxlink (Twisted Pair Or Fiber) Receivers (For Selected Video Output); Audio Settings; Inputs Only - General - AMX Enova DGX 100 Series Hardware Reference Manual

DXLink (Twisted Pair or Fiber) Receivers (for selected video output)

DXLink Details button – click to display additional settings for the DXLink Receiver (FIG. 110).

FIG. 110
DXLink (Twisted Pair or Fiber) Receivers
DXLink Receivers Settings
DXLink Quality
Firmware Version
Friendly Name
IP Address
Subnet Mask
D. P. S.
MAC Address
Auto-Setup
DIP Settings
Reboot button
Refresh button

Audio Settings

Audio settings display when the Switch Mode is A/V or Audio, the Audio tabbed view is selected, and a specific input or
output is selected. The audio settings can be used to configure any digital signal processing required for the audio signal
that is selected in the Switching view.

Inputs Only - General

FIG. 111
Audio Settings - Inputs Only - General
Audio Settings - Inputs Only - General
Stereo or Mono
buttons
Input Gain (dB)
Encoding
EDID Mode
Enova Digital Media Switchers - Hardware Reference Manual
green = good, red = poor
• DXLink Twisted Pair quality range is from -100 to 0 with the best quality at -100 and the worst quality at 0.
• DXLink Fiber quality range is from 0 to -100 with the best quality at 0 and the worst quality at -100.
current version
current name
for auto-setup, displays integrated Master's IP address
current setting
current setting
current setting
Status (Enable/Disable) and Force to Auto-setup button
indicates settings on DIP switch
reboots RX
updates status of RX settings
Setting this option to "Mono" audio on the input results in the left channel being sent to both the left and right output
channels.
use the slider bar to adjust (-24 dB to +24 dB),
PCM (read only)
from the drop-down list, select the mode (Basic, PCM 2-Channel, PCM Multi-Channel, Dolby Digital,
Dolby Digital + DTS, Dolby Digital + MPEG, Dolby Digital + AAC, Dolby TrueHD, Dolby Atmos, Dolby Digital Plus, or DTS
HD Master Audio).
System Configuration Interface
195