Locking And Unlocking; Locking The Control Panel; Unlocking The Control Panel; Adjusting Audio (Systems With Audio Switching Boards Only) - AMX Enova DGX 100 Series Hardware Reference Manual

Global Preset 3 is executed. The system now reflects the routing state that it was in when Global Preset 3 was defined.
The system returns to the Global Preset sub-menu.
7.
Press the Function key to return to the Function menu.
NOTE:
Status is not invalidated by global presets.

Locking and Unlocking

Locking the Enova DGX Control Panel prohibits access to the system and can prevent accidental switching. While the
panel is locked, BCS commands still work; however, they cannot be used to unlock the panel. The panel remains locked if
the power is cycled.
The password used to lock and unlock the panel consists of a sequence of five input keys. The factory default password is
the first five Input keys (1-2-3-4-5). A new password can be set using any combination of five keys from Input 1 through
Input 8 (for instructions, see page 79).
CAUTION: Record all passwords in a secure place; the Control Panel cannot be used to retrieve a lost password.
If the password is lost while the system is locked, contact technical support.

Locking the Control Panel

If you enter the wrong password while attempting to lock the Control Panel, the LCD displays "Invalid Password" and the
Cancel key flashes. Press the Cancel key to clear the error and enter the correct password.
NOTE:
For security purposes, the Input keys do not turn white when pressed while locking and unlocking the panel.
1.
Press the Function key. The Function menu appears.
2.
Locate Lock Panel by scrolling with the Control Dial.
3.
Press the Select key. The system is in Lock Mode (Input keys 1 through 8 turn blue).
4.
Press the Input keys in the following order: 1, 2, 3, 4, 5 (default password).
5.
The panel is locked, and all Input and Output keys turn off.

Unlocking the Control Panel

When the panel is locked and you press any key, the Unlock Panel Screen appears. You have ten (10) seconds to enter
the password or the Control Panel remains locked. If you wait longer than 10 seconds, press any key again before
entering the password.
NOTE:
If you enter the wrong password while attempting to unlock the Control Panel, an invalid password message
appears and the Cancel key flashes. Press the Cancel key to clear the error and enter the correct password.
1.
Press any key. The Unlock Panel screen appears (Input keys 1 through 8 turn blue).
NOTE: You must enter the password within ten (10) seconds.
2.
Press the Input keys in the following order: 1, 2, 3, 4, 5 (default password).
3.
The panel unlocks and returns to the Function menu.

Adjusting Audio (Systems with Audio Switching Boards Only)

IMPORTANT:
If the Enova DGX System contains Audio Switching Boards (ASB or ASB-DAN), the control panel supports three Audio
Modes for adjusting the embedded audio: Output Volume, Mute/Unmute, and Input Gain. If Audio Switching Boards are
not contained within the enclosure, the Adjust Audio control panel option will be nonfunctional.
IMPORTANT:
audio from an Audio Switching Board after it has been embedded on a video board.
NOTE: Complete audio signal processing functionality is available via the System Configuration interface (see page 184)
or via SEND_COMMANDs (see page 225).
Enova Digital Media Switchers - Hardware Reference Manual
This section on Adjusting Audio does not apply to Audio Insert/Extract Boards.
The Control Panel cannot directly access the audio on an Audio Switching Board. The Control Panel can only adjust the
Control Panel
74