Dxlink Video Settings; Dxlink (Twisted Pair Or Fiber) Transmitters (For Selected Video Input) - AMX Enova DGX 100 Series Hardware Reference Manual

DXLink Video Settings

DXLink specific video settings display when a DXLink Twisted Pair or DXLink Fiber Transmitter or Receiver (or other DXLink
equipment) is connected to the selected input or output. These settings display in addition to the normal video settings for
the input or output described in the previous section. The Video tabbed view must be selected.
Video Priority – click either the HDMI, Analog, or Manual button.

AV Source – click Analog or Digital.

Video Type – non-editable.

DXLink Details button – click to display additional settings for the DXLink Transmitter (FIG. 109)


DXLink (Twisted Pair or Fiber) Transmitters (for selected video input)

FIG. 109
DXLink (Twisted Pair or Fiber) Transmitters
DXLink Transmitters Settings
DXLink Quality
Firmware Version
Friendly Name
IP Address
Subnet Mask
D. P. S.
MAC Address
Auto-Setup
DIP Settings
Reboot button
Refresh button
VGA Settings
(DXLink Twisted Pair only)
IMPORTANT: The DXLink settings are not asynchronous. To obtain the latest information, the Refresh button in the dialog
box that opens when the DXLink Details button is clicked must be clicked.
NOTE: The 4k wall plate transmitter will only show the DxLink Details button which will only provide DxLink Quality data.
Enova Digital Media Switchers - Hardware Reference Manual
green = good, red = poor
• DXLink Twisted Pair quality range is from -100 to 0 with the best quality at -100 and the worst quality at 0.
• DXLink Fiber quality range is from 0 to -100 with the best quality at 0 and the worst quality at -100.
current version
current name
for auto-setup, displays integrated Master's IP address
current setting
current setting
current setting
Status (Enable/Disable) and Force to Auto-setup button
indicates settings on DIP switch
reboots TX
updates status of TX settings
use sliders to adjust Phase, Horizontal Shift, and Vertical Shift settings.
System Configuration Interface
194