Dxlink Rx Details; Edid Configuration; Setting An Enova Standard Edid For An Input; Setting A Custom Edid From An Output Sink - AMX Enova DGX 100 Series Hardware Reference Manual

DXLink RX Details

FIG. 119
DXLink Receivers Details
DXLink Receivers Details
DXLink Quality
Firmware Version
Friendly Name
IP Address
Subnet Mask
D. P. S.
MAC Address
Auto-Setup
DIP Settings
Reboot button
Refresh button

EDID Configuration

NOTE: Because signals routed through HDMI, DVI, DXLink Twisted Pair, and DXLink Fiber Boards in an Enova DGX 100 Series
Switcher normally produce a quality image, you will not need the information in this section unless the installation has
special EDID requirements.
A default EDID (Extended Display Identification Data) is stored on the input boards and/or Transmitters. This EDID, which
gets presented to the source, includes all necessary timings, audio and video format support, and preferred resolutions for
best performance.

Setting an Enova Standard EDID For an Input

1.
From Configuration page / Switch Mode (on the left), click the Video button.
2.
Check to be sure the Config Viewer on the top right is set to Inputs Only.
3.
From the Switching pane on the left, select the video input.
4.
Under General settings from the EDID Mode drop-down list, select the mode (All Resolutions, Wide-Screen,
Full-Screen, 4K, 4K60 or Custom). This will load the Enova Standard EDID of that type.
5.
If an alternate preferred resolution is desired, select the Preferred EDID from the drop-down list of resolutions/refresh
rates.

Setting a Custom EDID from an Output Sink

1.
From Configuration page / Switch Mode (on the left), click the Video button.
2.
Check to be sure the Config Viewer on the top right is set to Outputs Only.
3.
From the Switching pane on the left, select the video output.
4.
Return to the Input Configuration Page, use the Load EDID button to fetch the saved EDID from your PC and load in
onto the input.

Setting the EDID Mode For an Audio Input

1.
From Configuration page / Switch Mode (on the left), click the Audio button.
2.
Check to be sure the Config Viewer on the top right is set to Inputs Only.
3.
From the Switching page components on the left, select the audio input.
Enova Digital Media Switchers - Hardware Reference Manual
green = good; red = poor; number indicates degree or lack of quality
current version
current name
for auto-setup, displays integrated Master's IP address
current setting
current setting
current setting
Status (Enable/Disable) and Force to Auto-Setup button
indicates settings on DIP switch
reboots RX
updates status of RX settings
System Configuration Interface
199