Twisted Pair Cable Pinouts; Important Twisted Pair Cabling Requirements And Recommendations - AMX Enova DVX-315 HD Series Instruction Manual

Wiring and Device Connections

Twisted Pair Cable Pinouts

AMX supports both the T568A and T568B pinout specifications for termination of the twisted pair cable used between
the DVX and the DXLink receiver.
FIG. 40 Twisted pair cable pinouts for T568A (recommended) and T568B specifications

Important Twisted Pair Cabling Requirements and Recommendations

The following requirements and recommendations apply to cabling DXLink (RJ-45) connectors:




For more details and helpful cabling information, reference the white paper titled "Cabling for Success with DXLink"
available at
* "Common building" is defined as: Where the walls of the structure(s) are physically connected and the structure(s)
share a single ground reference.
30
DXLink cable runs require shielded category cable (STP) of Cat6 (or better).
DXLink twisted pair cable runs for DXLink equipment shall only be run within a common building.*
DXLink delivers 10.2 GB/s throughput over shielded category cable. Based on this bandwidth requirement,
we recommend following industry standard practices designed for 10 Gigabit Ethernet when designing and
installing the cable infrastructure.
The cables should be no longer than necessary to reach the end-points. We recommend terminating the cable
to the actual distance required rather than leaving any excess cable in a service loop.
www.amx.com or contact your AMX representative.
Enova DVX-315xHD & DVX-215xHD All-in-One Presentation Switchers - Instruction Manual