On-Screen Display; Image Adjustments - AMX Enova DGX 100 Series Hardware Reference Manual

Video Settings - Display Settings
Video Mute
Video Freeze
Test Pattern
Blank Color
Allow Display Sleep Click the check box to allow the display to go to sleep after the specified time in seconds in the "Display Sleep
Display Sleep
Display(s)

On-Screen Display

FIG. 107
On-Screen Display
Video Settings - On-Screen Display
Enable OSD
OSD Color
OSD Position

Image Adjustments

FIG. 108
Image Adjustments
Video Settings - Image Adjustments
Brightness
Contrast
Enova Digital Media Switchers - Hardware Reference Manual
Click the check box to mute the video
Click the check box to freeze the video
In the drop-down list, select Off, Color Bar, Gray Ramp, SMPTE Bar, HiLo Trak, Pluge, or X-Hatch
In the drop-down list, select Black or Blue
Delay(s)" field
Enter the delay in seconds that the display will remain awake after the video route has been disconnected or the
input signal is removed.
Note: While most monitors handle the sleep function well, some monitors continually attempt to wake up, resulting in
constant or intermittent screen blanking when no video is present. For the video output attached to the
problematic monitor, either uncheck the Allow Display Sleep option and set the Blank Color or set VIDOUT_SLEEP-
DISABLE and VIDOUT_BLANK-<color> (see page 228).
Click check box to enable/disable
In the drop-down list, select Black, Blue, White, or Yellow
In the drop-down list, select Top Left, Top Right, Bottom Left, or Bottom Right
Use the slider bar to adjust (range: 0 to 100)
Use the slider bar to adjust (range: 0 to 100)
System Configuration Interface
193