Cpu/Control Board (All Dgx 100 Series Enclosures); Overview - AMX Enova DGX 100 Series Hardware Reference Manual

CPU/Control Board (all DGX 100 Series Enclosures)

Overview

The CPU/Control board is identical for all DGX 100 Series Enclosures (FIG. 32). It is located on the left rear of the enclosure,
directly below the input connectors on the Enova DGX 800/1600/3200, and directly below the left bank of output
connectors on the Enova DGX 6400.
ICS LAN 10/100 port
SD card slot
FIG. 32
DGX 6400 - Rear Panel Components
CPU/Control Board Components
SD card slot
ICS LAN 10/100 port
System Status LED
Control port
Control port
NOTE:
integrated NetLinx NX Master, which uses the LAN 100/1000 and Program ports.
ID Pushbutton
AxLink port/Status LED
Config DIP switch
Program port
Communication Status
LEDs
LAN 100/1000 port
NOTE:
For an overview of integrated NetLinx NX Master functionality, see page 28.
Enova Digital Media Switchers - Hardware Reference Manual
DB-9 RS-232 serial Control port
System Status LED
Ships with an installed MicroSD memory card for future functionality.
RJ-45 connector for communication with endpoint devices in auto-setup configuration over ICS LAN
(private network).
NOTE:
Do not use for a TCP/IP connection or linking of enclosures.
Indicates system status (see page 283)
DB-9, RS-232 connector for attaching an external serial control device (see page 313).
USB mini-B connector for attaching an external control device (see page 313).
The Control ports provide direct control of matrix switcher processing. They do not work on the same layer of control as the
For selecting static IP or DHCP, resetting the factory defaults, and restoring the factory firmware image (see
page 60).
4-pin captive wire connector for supporting AMX AxLink devices. The LED to the right of the AxLink port
indicates AxLink data activity (see page 59).
2-position toggles for setting the Program Run Disable (PRD) mode (see page 61).
USB mini-AB connector for establishing a connection from the integrated NetLinx NX Master to the PC's
COM port (see page 58).
Status, Output, and Input LEDs indicate system communication status and indicating when data is sent and
received (for modes and blink patterns, see page 58)
Ethernet RJ-45 port for connecting from the integrated NetLinx NX Master to a public LAN (see page 56) for
all runtime control, NetLinx programming, etc.
CPU/Control Board (all DGX 100 Series Enclosures)
USB mini-B
Control port ID Pushbutton
AxLink port/Status LED
Configuration DIP switches
USB mini-AB
Program port
LAN 100/1000
port
Communication
Status LEDs
66