10-Band Parametric Equalizer; Dxlink Audio Settings; Dxlink (Twisted Pair Or Fiber) Transmitter (For Selected Audio Input) - AMX Enova DGX 100 Series Hardware Reference Manual

Audio Settings - Levels & Delay
Mute
Output Volume
Min/Max
Balance
Sync Delay (ms)

10-Band Parametric Equalizer

FIG. 115
10-Band Parametric Equalizer
Audio Settings - 10-Band Parametric Equalizer
Enabled
Tone Adjust
Reset EQ
Blue Handles
Equalizer Drop-down
menus

DXLink Audio Settings

DXLink specific audio settings display when a DXLink Twisted Pair or DXLink Fiber Transmitter or Receiver (or other DXLink
equipment) is connected to the selected input or output. These settings display in addition to the normal audio settings for
the input or output described in the previous section. The Audio tabbed view must be selected.

DXLink (Twisted Pair or Fiber) Transmitter (for selected audio input)

FIG. 116
DXLink (Twisted Pair or Fiber) Transmitter Settings
DXLink Transmitters Settings
Audio Priority
Audio Source
DXLink Details button
NOTE: The 4k wall plate transmitter will only show the DxLink Details button which will only provide DxLink Quality data.
Enova Digital Media Switchers - Hardware Reference Manual
click Mute if desired.
Note: Changing the volume level will not un-mute the signal; however, the new volume level is saved
and when the Mute button is deselected, the volume returns at the new level.
(0 to 100)
(0 to 100)
(-20 to 20, left to right)
(0 to 200)
this check box must be selected before the Equalizer options are available.
Note: On reboot, the Enabled box always returns to the checked (default) state. To disable the Equalizer
options over a reboot, set the "y" (vertical) vertex to 0 (zero).
use the drop-down box to select: Off, Voice, Music, or Movie (Tone Adjust is applied on top of any equalizer
adjustments).
Click to reset the all of the Equalizer values.
Use the sliders (blue handles) to adjust Equalizer values.
The following drop-down lists can also be used to adjust Equalizer values.
• Band – numbered from 1 to 10.
• Filter – the options are Bell, Band Pass, Band Stop, High Pass, Low Pass, Treble Shelf, and Bass Shelf.
• Frequency – the adjustment range is from 20 to 20000 (Hz).
• Gain – the adjustment range is from -12 to 12.
• Q – the adjustment range depends on the filter selected:
Bell = 0.1 to 20
Band Pass = 0.1 to 20
Band Stop = 0.1 to 20
High Pass = 0.5 to 1.4
Low Pass = 0.5 to 1.4
Treble Shelf = 0.5 to 1
Bass Shelf = 0.5 to 1
Click either the Auto or Manual button.
Click either the HDMI, SPDIF, or Analog button
Click to display additional settings for the DXLink Transmitter.
System Configuration Interface
197