Verifying Signal Status; Defining And Executing Global Presets - AMX Enova DGX 100 Series Hardware Reference Manual

1. Press the Function key. The Function menu appears.
2.
Locate Disconnect by scrolling with the Control Dial.
3.
Press the Select key. The system is in Disconnect Mode. All available Input and Output keys turn blue.
4.
Press Input keys 1 and 3 and Output key 9. The keys turn white indicating that they are selected.
5.
Press the Take key. Inputs 1 and 3 (and all outputs connected to them) and Output 9 are disconnected as soon as
the Take key is pressed and the keys turn blue.
6. Make additional disconnects.
- or -
Press the Function key to return to the Function menu.

Verifying Signal Status

The status of inputs or outputs can be checked using the Enova DGX Control Panel. Signal status can be verified to
confirm that a switch has executed properly or to confirm correct routing to multiple outputs (destinations). Verifying an
input will illuminate all outputs currently receiving the input's signal. An output can only be connected to one input
(source); therefore, verifying the status of an output will illuminate only the one input that is currently routed to it.
Once the Control Panel is in Status Mode, inputs and outputs can be selected by pressing the corresponding Input and
Output keys without changing the routing state. The panel stays in Status Mode until the Function key is pressed.
To verify signal status on a different virtual matrix, see "Changing the Virtual Matrix" on page 71.
1.
Press the Function key. The Function menu appears.
2.
Locate Status by scrolling with the Control Dial.
3.
Press the Select key. The system is in Status Mode (all available Input and Output keys turn blue).
4.
Press the Input key that corresponds to the input you want to check. The selected Input key turns white, and any
Output keys receiving the input signal also turn white.
- or -
Press the Output key that corresponds to the output you want to check. The selected Output key turns white, and if
an Input key routed to it, that key also turns white.
5.
Select another signal to verify.
- or -
Press the Function key to return to the Function menu.

Defining and Executing Global Presets

Global presets are predefined sets of switches that can easily be executed at one time. Each global preset is a snapshot
of the system's routing state and output volume settings at a particular time which can be recalled at a later time. The
system must be routed to the desired state before defining a global preset.
Global presets can be defined or recalled using either the Control Panel or BCS commands interchangeably.
The Control Panel on the Enova DGX Switcher supports up to 64 global presets. Because all 64 potential global preset
numbers are displayed in the Global Preset sub-menu, be aware that nothing indicates which of the numbers have been
assigned a routing state. A system state can be restored at any time by selecting the assigned global preset number.
Depending on whether or not the system includes Audio Switching Boards, global presets operate in one of two ways in
Enova DGX 100 Series Switchers:
Enova Digital Media Switchers - Hardware Reference Manual
Control Panel
72