Hdcp Compliance; Instagate Pro Technology; Dxlink Twisted Pair 4K Boards Specifications; Compatible Amx Dxlink- Twisted Pair 4K Transmitters And Receivers - AMX Enova DGX 100 Series Hardware Reference Manual

HDCP Compliance

If a connected downstream sink is not HDCP compliant, then the Output Board will not send the signal to it. This does not
affect other outputs the source may be routed to. This allows compliant displays to show content from source devices
even if the source devices are switched to non-compliant displays. Non-compliant displays can easily be identified
because they display a dark red image (via an HDMI/DVI Output) or an orange image (via a DXLink RX) to indicate that
the authentication process failed.

InstaGate Pro Technology

DXLink Twisted Pair 4K Boards meet HDCP standards and support InstaGate Pro Technology. For information on

HDCP functionality for DXLink boards, see "HDCP Support on Enova DGX Switchers" on page 98.
DXLink Twisted Pair 4K Boards provide EDID emulation support with plug-and-play information provided by the

Enova DGX Switcher.
DXLink Twisted Pair 4K input and output connectors incorporate HDMI Technology, are HDCP 1.4 compatible, and

feature InstaGate Pro Technology* for low-latency switching of HDCP protected content. The DXLink Twisted Pair
4K connectors also support embedded audio, both linear PCM (stereo audio) and non-linear PCM (Dolby Digital,
Dolby TrueHD, DTS, etc).

DXLink Twisted Pair 4K Boards Specifications

Applies to input board FG1061-570 (DGX-I-DXL-4K) and output board FG1061-580 (DGX-O-DXL-4K). This section applies to
products with full compatibility (including a complete 4K signal path). For compatibility between DXLink Twisted Pair 4K
products and DXLink Twisted Pair products, see the DXLink Twisted Pair 4K Transmitters and Receivers Hardware Reference
Manual.

Compatible AMX DXLink- Twisted Pair 4K Transmitters and Receivers:

DXLink 4K HDMI Decor Style Wallplate TX: FG1010-330-BL and FG1010-330-WH (DX-TX-DWP-4K)

DXLink 4K HDMI RX: FG1010-510 (DX-RX-4K)


Compatible AMX Solecis 4K Digital Switchers (1 Output per Switcher):

Solecis 4x1 4K HDMI Digital Switcher with DXLink Output: FG1010-314 (SDX-414-DX)

Solecis 5x1 4K Multi-Format Digital Switcher with DXLink Output: FG1010-355 (SDX-514M-DX)

IMPORTANT: DXLink twisted pair cable runs for DXLink equipment shall only be run within a common building. "Common
building" is defined as: Where the walls of the structure(s) are physically connected and the structure(s) share a single
ground reference.
DXLink Twisted Pair 4K Input and Output Boards - Specifications
Compatible AMX DXLink™
Twisted Pair 4K Products
Compatible Formats
Signal Type Support
Transport Layer Throughput
(max.)
Video Data Rate (max.)
Video Pixel Clock (max.)
Progressive Resolution Support
Interlaced Resolution Support
Deep Color Support
Color Space Support
3D Format Support
Enova Digital Media Switchers - Hardware Reference Manual
4K HDMI Decor Style Wallplate TX, 4K HDMI RX, other AMX DXLink signal management products
Note: For additional compatibility with DXLink Twisted Pair products, see the "DXLink Twisted Pair 4K
Transmitters and Receivers Hardware Reference Manual" at www.amx.com.
HDMI Video, Audio, Ethernet, USB (HID), Power, and Control
DXLink Twisted Pair
10.2 Gbps
8.91 Gbps (max)
297 MHz
480p up to 4096x2160p,60 Hz (Y/Cb/Cr 4:2:0 and 4K RX Scaler in Bypass)
Note: See full list of supported formats on page 125.
480i, 576i, 1080i
If input is interlaced, all scaled outputs will de-interlace video to a progressive resolution format. If in
scaler Bypass mode, interlaced input will pass through unaltered.
Up to 1080p: 24-bit, 30-bit, 36-bit
30-bit, 36-bit only supported when the HDMI Output Board Scaler or DXLink RX Scaler is in Bypass mode
and format is 1080p60 or less.
• RGB 4:4:4
• YCbCr 4:4:4, 4:2:2, and 4:2:0
Input signal for YCbCr 4:4:4 and 4:2:2, output color-space is converted to RGB 4:4:4.
4:2:0 only supported at 2160p 50/60Hz with 4K RX Scaler in Bypass.
HDMI primary formats, when used with DXLink Output Boards and the RX Scaler is in Bypass mode
• Frame Packing 1080p up to 24 Hz
• Frame Packing 720p up to 50/60 Hz
• Frame Packing 1080i up to 50/60 Hz
• Top-Bottom 1080p up to 24 Hz
• Top-Bottom 720p up to 50/60 Hz
• Side-by-Side Half 1080i up to 50/60 Hz
DXLink Twisted Pair 4K Input and Output Boards
124