Table of Contents
Advertisement
Problem
With power switch in on
position, fryer is com-
pletely without power.
Filter motor runs but
pumps oil slowly.
80
Cause
Wrong cook button pushed.
Temperature programmed too low
or not programmed.
Temperature probe out of
calibration.
Slow fryer heat-up/recovery.
P P o o w w e e r r S S e e c c t t i i o o n n
Open circuit.
F F i i l l t t e e r r S S y y s s t t e e m m S S e e c c t t i i o o n n
Pump clogged.
O-rings worn, damaged, or
missing.
Clogged filter envelope
Wet filter envelope
Correction
page 64
to see if the controls sensed any
overloaded batches.
If fryer hasn't been used since problem
batch, see
5.1 Information Mode Details ,
page 44
4B and 5B to see what product
was selected.
5.2.1 Diagnostic Mode Details ,
See D10 of
page
64; if temperature settings have been
changed, have the controls re-initialized.
Check temperature probe calibration; see
Checking Temperature Probe Calibration
section; if between 5 and 15 degrees off,
calibrate probe; if more than 15 degrees off,
replace probe.
5.2.1 Diagnostic Mode
•
See D4 of
Details , page 64
for the present day's
5.1 Information
performance; or see
Mode Details , page 44
information on this problem.
•
Low voltage; see D3 of
Mode Details , page 64
voltage performance; for more
information see
5.1 Information Mode
Details , page 44
•
Check to see if fryer is plugged in.
•
Check wall circuit breaker or fuse.
•
Have a qualified service technician
check power supply and power switch.
Have pump cleaned.
o-rings3.8.3 Quarterly
Replace drain pan
Drain Pan O-Ring Replacement , page 34
Clean drain pan, empty crumb basket, and
replace filter
envelope3.6 Drain Pan As-
sembly , page 27
Dry drain pan and replace filter
Drain Pan Assembly , page 27
for more
5.2.1 Diagnostic
for present day's
envelope3.6
Advertisement
Table of Contents
