Table of Contents
Advertisement
Menu Step
SP-8
SP-8A
SP-8B
SP-8C
SP-9
40
Display Name
The "2.LIQ" setting allows a more aggressive heat-up rate,
but should only be used if liquid oil is in the frypot.
IDLE MODE
Idle mode enable setting (YES, NO). Press the down button
ENABLED?
to change from YES to NO.
Idle mode regulates the oil at a lower temperature to save
energy and extend shortening life during low demand
periods
If enabled, the Idle mode may be activated either
automatically or by manual pushbutton selection, depending
on the [SP‑8B] and [SP‑8C] settings below. Cook mode is
resumed by pressing any product button.
IDLE SETPT TEMP
Press up and down buttons to set the temperature (190°F - 380°F)
for Idle mode. Default temperature is 250°F.
AUTO-IDLE MINUTES Period of inactivity (OFF, 1 - 60 min.) that triggers activation of Idle
mode. This timer starts when the fryer recovers back to set point
temperature.
USE 6 FOR IDLE
Manual Idle button enable by pressing the down button
(YES, NO).
If set to YES, and Idle Mode is enabled, then the "6" button
is used as a Manual Idle button: pressing the "6" button
while in Cook mode will immediately activate Idle (setback)
mode.
PRODUCT BUTTONS
1.COOK: Pressing a product button selects and immediately
starts a cook cycle for that product. The Timer button is used
to stop cook cycles. The appropriate product button must be
pressed each time a cook cycle is started. This is the default
setting.
2. SELECT: Pressing a product button only selects that
product for cooking. The Timer button must be used to start
a cook cycle. The Timer button is also used to stop a cook
cycle. Subsequent cook cycles for the same product can be
started by simply pressing the Timer button again, as the
product is already selected and its name is shown on the
display.
Function
Advertisement
Table of Contents
