Table of Contents
Advertisement
Roll new O-ring into notch on tube. Lubricate O-rings on filter tube with fresh, cold oil and push
3 3 ) )
filter drain pan into position (lubricate first before installing).
3 3 . . 8 8 . . 4 4 Q Q u u a a r r t t e e r r l l y y F F i i l l t t e e r r S S c c r r e e e e n n O O - - R R i i n n g g R R e e p p l l a a c c e e m m e e n n t t
To prevent oil leaking, and to keep filtering process operating properly, the filter drain pan and filter
screen o-rings should be replaced every three months.
D D r r a a i i n n p p a a n n c c o o u u l l d d b b e e h h o o t t ! ! W W e e a a r r P P P P E E ( ( p p e e r r s s o o n n a a l l p p r r o o t t e e c c t t i i v v e e e e q q u u i i p p m m e e n n t t ) ) h h e e a a t t a a n n d d o o i i l l
r r e e s s i i s s t t a a n n t t g g l l o o v v e e s s , , o o r r s s e e v v e e r r e e b b u u r r n n s s c c o o u u l l d d r r e e s s u u l l t t . .
Push down on the drain pan latch and pull out the drain pan assembly, using the handle on the
1 1 ) )
drain pan.
Remove the contents from the drain pan (refer to
2 2 ) )
the Filter Screen.
To replace o-rings, use a small flat-bladed screwdriver and pry up on each o-ring and pull off
3 3 ) )
the end of tube.
3.6 Drain Pan Assembly , page
27) to access
35
Advertisement
Table of Contents
