Mitsubishi Electric MELSERVO-JE Instruction Manual page 103

6. SERVO MOTOR DRIVING
(1) Details on the Controlword (6040h) (pv mode)
Bit Symbol
4
(reserved)
5 (reserved)
6 (reserved)
8
HALT
9
(reserved)
15
New set-point
(2) Details on the Statusword (6041h) (pv mode)
Bit Symbol
10 Target reached
12 Speed
13 Max slippage error
Note. This is not compatible with the MR-JE-_C servo amplifier.
The value at reading is undefined. Set "0" when writing.
0: The servo motor is driven.
1: The servo motor is stopped according to Halt option code (605Dh).
The value at reading is undefined. Set "0" when writing.
0: The servo motor is stopped.
1: The servo motor is driven.
Enabled only in the profile velocity mode.
When "_ _ _ 0" (enabled) is set in [Pr. PC23 (_ _ _ x) Servo-lock selection at speed control stop],
the servo motor is driven by setting bit 15 to "1". When bit 15 is set to "0" while the servo motor is
stopped, the servo motor goes into the servo-lock status. When bit 15 is set to "0" while the servo
motor is being driven, the servo motor decelerates to a stop and goes into the servo-lock status.
When "_ _ _ 1" (disabled) is set in [Pr. PC23 (_ _ _ x)], the servo motor is driven by setting Target
velocity regardless of the setting of bit 15.
0 (Halt (Bit 8) = 0): Target velocity not reached.
0 (Halt (Bit 8) = 1): Axis decelerates
1 (Halt (Bit 8) = 0): Target velocity reached.
1 (Halt (Bit 8) = 1): Velocity of axis is 0
Judgment condition for Target velocity reached
If the error between Velocity actual value (606Ch) and Target velocity (60FFh) has stayed within
Velocity window (606Dh) for Velocity window time (606Eh) or more, Target velocity reached is
stored.
0: Speed is not equal 0
1: Speed is equal 0
Judgment condition for Speed is not equal 0
If the absolute value of Velocity actual value (606Ch) has exceeded Velocity threshold (606Fh)
for Velocity threshold time (6070h) or more, Speed is not equal 0 is stored.
0: Maximum slippage not reached
1: Maximum slippage reached (not compatible) (Note)
Max slippage is a maximum slippage of the asynchronous servo motor.
6 - 38
Description
Description