Configuring The Wireless Lan Settings - Ricoh SP 203SF Manual

1. Guide to the Machine
Assigning the machine's IPv6 address manually
• The IPv6 address assigned to the machine must not be used by any other device on the same
network.
• Check that [LAN Type] is set to [Ethernet] in [Interface Settings] in Web Image Monitor.
1. Launch the Web browser.
2. In the address bar, enter "http://(machine's IP address)/".
3. Click [Log in].
4. Enter the administrator password, and then click [Log in].
If you are logging in for the first time, enter "admin133" as the password.
5. Click [IPv6].
6. Set [IPv6] to [Enable].
7. Set [DHCPv6] to [Disable].
8. Specify the IP address in [Manual Configuration Address].
9. Specify other settings if necessary.
10. Click [OK].
• For details about configuring the IPv4 address, see the Software Installation Guide.

Configuring the Wireless LAN Settings

• Check that [LAN Type] is set to [Wireless LAN] in [Interface Settings] in Web Image Monitor.
Configuring the communication mode
You can select infrastructure mode or ad-hoc mode.
• Infrastructure Mode
Select this to communicate via an access point.
For details about configuring infrastructure mode, see Wi-Fi Settings Guide.
• Ad-Hoc Mode
Select this to connect directly to a device equipped with wireless LAN (such as a laptop).
In Ad Hoc mode, configure the following settings to match those of the host computer.
• IP address
40
opal-p1_mf1_wi-fi_user_guide_gb_00104816_eng.xml
Draft 2013/03/07