Ricoh SP 203SF Manual page 32

1. Guide to the Machine
1. Press the [User Tools] key.
ctt129.pdf (alt="User Tools key
2. Press the [
select [Network Settings], and then press the [OK] key.
3. Press the [
select [Machine IPv6 Address], and then press the [OK] key.
4. Press the [
select [Use IPv6], and then press the [OK] key.
5. Make sure [Use IPv6] is set to [On].
If this setting is changed, the machine will reboot automatically before the procedure is complete.
When this happens, wait for the reboot to finish, repeat Steps 1 to 3, and then proceed to the next
step.
6. Press the [
select [Manual Config. Add.], and then press the [OK] key.
7. Press the [
select [IP Address], and then press the [OK] key.
8. Enter the machine's IPv6 address using the number keys.
9. Enter the values in all fields, and then press the [OK] key.
If this setting is changed, the machine will reboot automatically before the procedure is complete.
When this happens, wait for the reboot to finish, repeat Steps 1 to 3, and then proceed to the next
step.
10. Press the [
select [Prefix Length], and then press the [OK] key.
11. Enter the prefix length using the number keys, and then press the [OK] key.
After a setting is changed, the machine automatically restarts.
• Install the driver after configuring the IPv6 address. For details about installing the driver, see the
Software Installation Guide.
32
illustration" title="")
(alt="Down arrow key"
(alt="Down arrow key"
(alt="Down arrow key"
(alt="Down arrow key"
(alt="Down arrow key"
(alt="Down arrow key"
CTT129
title="")] or [ (alt="Up arrow
title="")] or [ (alt="Up arrow
title="")] or [ (alt="Up arrow
title="")] or [ (alt="Up arrow
title="")] or [ (alt="Up arrow
title="")] or [ (alt="Up arrow
opal-p1_mf1_wi-fi_user_guide_gb_00104815_eng.xml
key" title="")] key to
key" title="")] key to
key" title="")] key to
key" title="")] key to
key" title="")] key to
key" title="")] key to
Draft 2013/03/07