Ricoh SP 203SF Manual page 167

wim003.tif (alt="web browser screen illustration
IPv4
Item
IPv4
Ethernet
Item
Host Name
DHCP
Domain Name
IPv4 Address
Subnet Mask
opal-p1_mf1_wi-fi_user_guide_gb_00104861_eng.xml
" title="")
Indicates that IPv4 is enabled.
Enter the host name you want to set for the network interface board or wireless
LAN interface unit, using up to 63 characters. The default is RNP, followed by
the MAC address of the active interface board. If you change the name to other
than the default, the new name cannot begin with "RNP" or "rnp".
Select [Enable] to automatically configure the network settings using the DHCP
server. Select [Disable] to manually configure the network settings.
Specify whether to use the domain name obtained from the DHCP server, or the
domain name set for the device.
• "Auto-Obtain (DHCP)" selected
When using DHCP, the domain name obtained from the DHCP server is
used. If the domain name cannot be obtained from the DHCP server, the
domain name set for the device is used.
• "Specify" selected
The domain name set for the device is used. Enter the domain name, using
up to 63 characters. Spaces cannot be used.
Enter the IPv4 address of the network interface board or wireless LAN interface
unit.
At DHCP operation, the address obtained from the DHCP server is used.
Enter the sub-net mask of the network interface board or wireless LAN interface
unit. The sub-net mask is a part of the IP address used as a network address.
Using Web Image Monitor
Description
Description
167
Draft 2013/03/07