Ricoh SP 203SF Manual page 227

Code
E1 Tray 1 has run out of paper.
E3 The front cover or fusing cover is open.
E4 The bypass tray has run out of paper.
An appropriate size paper for printing
E5
Report is not loaded.
The print cartridge has not been
E6
installed.
E7 The machine has run out of the toner.
E8 The print cartridge is almost empty.
The paper for ID Card copy is not
E9
loaded.
If paper is loaded in the bypass tray
e2 when printing with the paper fed from
Tray 1, you cannot print.
The specified paper size of the file does
P1 not match that of the paper loaded in
Tray 1.
The specified paper type of the file does
P2 not match that of the paper loaded in
Tray 1.
The specified paper size of the file does
P3 not match that of the paper loaded in
the bypass tray.
opal-p1_mf1_wi-fi_user_guide_gb_00104878_eng.xml
Causes
Error and Status Indicate on the Control Panel
Solutions
Load paper into Tray 1. See page 51
"Loading Paper".
Close the front cover or fusing cover
completely.
Load paper into the bypass tray. See page 51
"Loading Paper".
Load the appropriate size paper.
Reinstall the print cartridge. See page 195
"Replacing the Print Cartridge".
Replace the print cartridge. See page 195
"Replacing the Print Cartridge".
Prepare a new print cartridge.
Load the appropriate size paper.
Remove the paper loaded in the bypass tray.
Press the [Start] key to begin printing, or press
the [Stop/Clear] key to cancel the job.
Press the [Start] key to begin printing, or press
the [Stop/Clear] key to cancel the job.
Press the [Start] key to begin printing, or press
the [Stop/Clear] key to cancel the job.
227
Draft 2013/03/07