Table of Contents
Advertisement
•
Operating temperature -20°C - +60°C (-4°F - +140°F).
•
The stand must be used when base station is placed on moist ground, e.g., on a wet
lawn.
•
When the base station is placed on the wall, the plug must be towards the ground,
especially outdoors.
•
During charging the legs of the base station must be used because the bottom heats up.
The bottom of the base station heats up to 60°C (140°F).
•
During charging, the maximum operating temperature is 45°C (113°F).
•
It is recommended that the base station is placed 2 meters (6.5 ft) above the ground to
optimize the signal.
•
Check the range of the signal if the base station is surrounded by metal.
•
Wall mount and legs included.
•
The sockets that are provided in the wall mounting kit are meant for concrete surfaces.
Charger
Charger is used to re-charge the batteries of the transmitters. The charger can be used only
indoors. Data transfer (transmitter settings, memory contents) between the transmitters and the
PC is enabled only when the transmitters are inserted into the charger.
To transmit data between transmitters and PC, follow these instructions:
1. Turn on your PC and open Team
2. Connect the base station to PC according to the instructions.
3. Plug the power cable into the charger.
4. Insert transmitters into the charger. Wait until (3) is lit in the base station.
If the transmitter is inserted correctly into the charger, you hear one short sound and red led is on
for 5 seconds. Software's
connected to the base station/USB dongle.
2
software.
toolbar
shows in the upper right corner how many transmitters are
Team2 SW help
19
Advertisement
Table of Contents
