Table of Contents
Advertisement
Red led is blinking every 5
seconds.
Green led is blinking
every 10 seconds.
Green led is on.
Red led is on for 5
seconds.
Three short sounds.
Wizard
Wizard launches when the Team
introduction process step by step. Before you can run Team
your PC.
If you want to run Wizard again at some point, remove all the transmitters from the system
according to the instructions, shut down the software and re-run it. Wizard then launches
automatically.
•
Wizard can be stopped at any time by clicking the Cancel button.
•
It is possible to shift between the steps by clicking the Next and Back buttons.
NOTE: These instructions apply only to the initialization wizard that launches when the Team
software is run for the first time. For instructions on the rest of the software, see the
chapter.
Welcome (Step 1)
Transmitter is charging.
Transmitter's battery is full.
The user can activate the connection between a new transmitter and the system and
activate the transmitter's number while introducing new transmitters to the system.
Transmitter is properly placed into the charger, but is in not-secured mode. Data
cannot be transferred while the transmitter is in not-secured mode.
To be able to transfer data from the transmitter to the PC or to change the transmitter's
settings, change the mode to secured by removing the transmitter from the charger
and inserting it back after a minimum of 3 seconds. Only one sound should be heard.
2
software is run for the first time. Wizard guides you through the
Team2 SW help
2
software you have to install it on
2
software
7
Advertisement
Table of Contents
