Table of Contents
Advertisement
Team2 SW Help
Transmitter/Player is not shown
during online training.
148
disconnected.
5) Base station's battery is empty.
6) The transmitter is out of the base
station's range.
1) Transmitter's battery is empty.
2) Strap's electrode areas are dry or
strap is secured incorrectly.
3) Connection between the PC/PDA
and the base station is momentarily
disconnected.
4) Base station's battery is empty.
5) There is not a player assigned to
the transmitter.
6) Transmitter is in off-season
mode.
areas are firmly against player's
skin.
4) Wait for a moment. If connection
is not restored, switch the base
station off and on again. Also re-
open the software and establish
connection between PC and base
station normally.
5) Plug the power cable into the
base station.
6) Wait until the player is again in
the base station's range. The
transmitter has a buffer memory so
short gaps can be corrected during
the online training.
Cases 4 and 6: If there is a long gap
(several minutes) in data recording
during the online training, the data
can be completed by transferring
the data from the transmitter's
memory after the online training
according to the instructions.
1) Recharge transmitter's battery.
2) Wet the electrode areas of the
strap under running water. Make
sure that the strap is secured
correctly
and the wet electrode
areas are firmly against player's
skin.
3) Wait for a moment. If connection
is not restored, switch the base
station off and on again. Also re-
open the software and establish
connection between PC and base
station normally.
4) Plug the power cable into the
Advertisement
Table of Contents
