Table of Contents
Advertisement
allowed. Finish the transfer of other training files to your Team
the failed transmitters to secured mode by removing the transmitters from charger and
inserting them back after a minimum of 3 seconds. Only one sound should be heard.
Repeat the file transfer with these transmitters.
Transmitters
How to Add Transmitters
When the original 10 transmitters are not enough, transmitters have not been added during
Wizard or some of the original transmitters have to be re-added, the Add new transmitter
function becomes handy. New transmitters can be added by using the base station or the USB
dongle. You can add up to 10 transmitters at a time. A maximum of 80 transmitters can be added
to the system.
Do not attach number labels to empty transmitters beforehand!
1. Open the Team
2.
Connect the main base station to the
3. Remove the old (previously added) transmitters from the charger.
4. Click Tools > Add New Transmitter. A popup window appears.
5. Make sure that you have either the base station connected to the PC (lights 1 and 2 are
on) or you have plugged in the USB dongle.
6. Insert the new transmitters into the charger and plug the power cable into the charger.
7. Wait until found transmitters start appearing under heading New on the left.
8. Select one of the new transmitters from the list by clicking. Wait until the transmitter is
moved under heading Added. At the same time, a green light is lit on one of the
transmitters in the charger. NOTE: It may take couple of second the green light to light up!
9. Remove the transmitter that has a green light on it from the charger.
10. Mark the transmitter with number label that is in accordance with transmitter's number
shown on the screen.
11. Repeat steps 8 to 10 until all the transmitters are added and labeled.
12. End by clicking the Finish button.
2
software.
PC.
Team2 SW help
2
system normally. Switch
119
Advertisement
Table of Contents
