Transmitters - Polar Electro Team2 Manual

Team2 SW Help

Transmitters

Below you can find help to some common problems with transmitters. Go through the list to get
firsthand help.
Problem
The transmitter cannot be taught to
the system.
Training data cannot be transferred
from the transmitters to PC.
There's a yellow warning triangle in
the upper right corner of the
software and in the Transmitters
tab of software preferences.
When inserted into charger, there is
no sound or light.
Transmitters are not shown as
152
Cause
The transmitter is in secured mode,
because it has already been paired
with another base station.
Transmitter is in non-secured mode,
because it is removed from and
inserted back into the charger within
3 seconds.
The base station combination has
been changed (added or removed)
and base station information has not
yet synchronized to the transmitters.
1) Power cable is not plugged into
the charger.
2) Transmitter is inserted into
charger incorrectly.
1) Power cable is not plugged into
Solution
Change the transmitter's mode to
non-secured by removing the
transmitter from the charger and
inserting it back within 3 seconds.
When inserted into the charger,
three short sounds are heard
instead of one. Note that after you
have taught the transmitter to the
system, the connector's mode is
automatically changed to secured.
Change the transmitter's mode to
secured by removing the transmitter
from charger and inserting it back
after a minimum of 3 seconds. Only
one sound should be heard.
See the instructions in How to
synchronize transmitters with new
base stations.
1) Plug the power cable into charger
and into the wall outlet.
2) Insert transmitter into the charger
so that the P of Polar logo is not
visible. The led is located next to
the R of Polar logo.
1) Plug the power cable into charger