Table of Contents
Advertisement
•
Check that the lights next to the Ethernet port on your PC are flashing. The flashing
means that the connection is working.
•
Make sure that your Ethernet adapter is enabled:
1. Select Start > Control Panel > Network connections.
2. Right-click Local Area Connection.
3. If the right-click menu includes option Enable, the adapter is at the moment
Disabled. In this case, select Enable.
•
Make sure the lights of the Ethernet port on your PC are flashing.
If you have checked all the issues mentioned above:
1. Close the software and switch off the main base station.
2. Open the software and switch on the main base station again.
If the connections still do not work, check that the status of your LAN connection is Connected
and the IP address of the base station is 192.168.42.x (x can be any number):
1. Select Start > Control Panel > Network connections.
2. Right-click Local Area Connection and select Status. The status is displayed on the
first page.
3. Select Support tab. The IP address is displayed.
If you have checked all the issues mentioned above:
•
Try to reboot your PC.
•
Update the drivers of the LAN adapter. Contact the adapter's manufacturer's web site.
PC and Wireless connection
The step-by-step instructions for wireless connection can be found in the
•
Make sure that the Team
•
Make sure that the main base station is switched on.
2
software is running.
Team2 SW help
hardware
section.
145
Advertisement
Table of Contents
