Kyocera 13600 Adjustment Manual page 73

0615: [Z-fold Skew Correction]
Specify how to correct skew (occurring during paper transport) when Z-folding with the folding unit.
If [Off] is selected, skew is not corrected.
If [On] is selected, skew is corrected by bringing the sheets flush against a guide.
If [On (Reverse)] is selected, skew is corrected by bringing the sheets flush against a guide while the
registration roller rotates in reverse to prevent the Z-folded sheets from passing through the registration
roller.
Setting Items
[Z-fold Skew Correction]
0616: [Correct Z-fold Skew]
Adjust the length of sheets moved for Z-fold skew correction.
Use this if the Z-fold skew correction causes problems.
With the factory default setting of "0.0", the length of the sheets moved is set to 9 mm. Press [−] to reduce
the length. With "-9.0", the length of sheets moved for Z-fold skew correction is reduced to "0".
Setting Items
[Correct Z-fold Skew]
0617: [Correct Z-fold Skew (Reverse)]
Adjust how much the registration roller rotates in reverse for Z-fold skew correction.
Use this if the Z-fold skew correction causes problems.
With the initial factory setting of "0.0", the reverse rotation is set to 3 mm. Press [−] to reduce the reverse
rotation. With "-3.0", the reverse rotation is reduced to 0 mm.
Setting Items
[Correct Z-fold Skew (Reverse)]
Values
[On]
[On (Reverse)]
[Off]
Default Max.
Value Value
0.0 0.0
Default Max.
Value Value
0.0 0.0
Setting Values
Default Value
[On (Reverse)]
Min.
Step
Value
-9.0 0.5
Min.
Step
Value
-3.0 0.5
Unit
mm
Unit
mm
71