Kyocera 13600 Adjustment Manual page 52

2. Details of Menu Items in Adjustment Settings for Skilled Operators
Code
2 Developer setup failure
9 Replenishment quit forcefully
0512: [ITB Manual Lubrication]
Lubricate the intermediate transfer belt.
Lubrication makes the surface of the intermediate transfer belt smoother, which extends the life of the
cleaning unit for the intermediate transfer belt.
This operation takes about 5 minutes during which a message appears on the control panel.
After you have replaced the cleaning unit for the intermediate transfer belt, lubricate it. For details about
lubricating the unit, see the Replacement Guide.
[Execute ITB Manual Lubrication]
0515: [Reset Replaceable Parts Counter]
Reset the duty cycle counter for replaceable parts.
After replacing a part, reset its duty cycle counter. For details about replacing units, see the Replacement
Guide.
50
Status
Setting Items
Causes
• The developer bottle is
not attached to the
outlet.
• The developer bottle is
attached to the inlet,
but its seal has not
been pulled out.
• The front covers have
been closed.
• The power was turned
off during the
operation.
Press [OK] to apply the setting(s).
Solutions
Attach a new developer
bottle to the inlet, pull out
the seal, and then try the
operation again.
Open the front covers, turn
on the main power, and
then try the operation again.
Values