Kyocera 13600 Adjustment Manual page 22

2. Details of Menu Items in Adjustment Settings for Skilled Operators
[Machine: Image Quality]
For details about the following items, see page 34 "[Machine: Image Quality]".
No.
0201 [Adjust Erase Margin With
Feed Direction]
0202 [Adjust Image Density]
0203 [Image Density Adjustment
Execute Interval]
0204 [Adjust Maximum Image
Density]
0205 [Adjust Line Width]
0206 [Adjust Density Difference
Across Feed Direction]
0207 [Adjust Fusing Temperature
on Standby]
0208 [Avoid Ppr Trnsf Shock
Jitter: Feed Interval Adj]
0211 [Toner Refreshing Mode]
0212 [Productivity Priority Mode] Specify whether or not to increase throughput on a job
0213 [Continuous Slip Sheet
Feed Mode]
*1 A shock that occurs as the leading or trailing end of paper passes through the transfer unit. When this
shock is transmitted to the drum via the intermediate transfer belt, banding occurs.
[Machine: Paper Feed/ Output]
For details about the following items, see page 39 "[Machine: Paper Feed/ Output]".
20
Item
Adjust the mask width at the leading edge or trailing
edge of the image.
Execute image density control manually.
Specify the number of sheets the machine prints before it
automatically adjusts image density.
Specify the adhesion of toner to the drum surface and
intermediate transfer belt when image density adjustment
is executed.
Adjust the intensity of the laser for transferring image
data to the drum.
Adjust the image density difference between the top and
bottom of the image.
Adjust the set fusing temperature according to the
machine status.
Specify whether or not to enable the mode to reduce the
*1
jitter
roller.
Specify the threshold for the average image area ratio at
which toner refreshing mode is enabled.
that involves printing on thick and then on thin paper.
Specify whether or not to temporarily stop the imaging
unit in order to avoid reductions in image quality that
may occur in continuous slip sheet feed mode.
Description
produced when paper enters the paper transfer