Kyocera 13600 Adjustment Manual page 127

Once a job starts, the fusing pressure roller comes into contact with the fusing belt after the time specified
in this setting has elapsed.
If this is set to 30 seconds, the fusing pressure roller comes into contact with the fusing belt 30 seconds
after a job starts, and printing starts once warm-up is complete (when the temperature at which paper
feeding is allowed is reached).
Use this to adjust the fusibility and reduce image degradation (such as uneven luster and blisters).
If you reduce the starting time, the temperature drop the machine is able to handle can be increased, but
uneven luster may occur.
If you increase the starting time, the temperature drop the machine is able to handle is reduced, but
uneven luster is reduced.
Press [+] or [−] to adjust the start timing.
Setting Items
[Starting Time of Putting Pressure before
Fusing]
46: [Fusing Heat Roller Temperature Adj]
Adjust the heat roller temperature.
Press [+] to increase the temperature and [−] to reduce it.
• Decreasing the temperature too much may cause the toner to not properly fuse to the paper (cold
offset).
• Increasing the temperature too much may distort the paper and cause glossy lines, paper jams,
and insufficient toner fusing (hot offset).
• Depending on the type of paper, you can increase the toner gloss by increasing the temperature
by 5 to 10°C over the initial factory setting.
Setting Items
[Fusing Heat Roller Temperature
Adjustment]
47: [Fusing Pressure Roller Temperature Adj]
Adjust the pressure roller temperature.
Press [+] to increase the temperature and [−] to reduce it.
Max. Value Min. Value
500.0 0.0
Max. Value Min. Value
200 100
Setting Values
Step Unit
0.1 second(s)
Step Unit
1 degree(s)
125