Kyocera 13600 Adjustment Manual page 128

4. Details of Menu Items in Advanced Settings
• Decreasing the temperature too much may cause the toner to not properly fuse to the paper. (cold
offset).
Setting Items
[Fusing Pressure Roller Temperature
Adjustment]
48: [Fusing Nip Width Setting]
Adjust the nip width between the fusing belt and the pressure roller.
You can reduce creases produced when printing envelopes.
The default setting is 2. To reduce creases, change the setting to 4.
However, doing this may result in insufficient toner fusing, causing toner to shed from the envelopes
(cold offset).
Although values from 1 to 4 are displayed, 1 and 3 are not usable.
Setting Items
[Fusing Nip Width Setting]
49: [Paper Feed Interval Setting]
Adjust the interval between the feeding of each sheet.
The standard interval is "100". If you set this to "50", the throughput will be reduced in half.
Press [+] to increase the interval and [−] to reduce it.
• Depending on the fusing unit's temperature and the size of paper, if you increase the interval by
pressing [−], the copy/print speed may decrease.
Setting Items
[Paper Feed Interval Setting]
50: [Reduce Initial CPM: Low Temp. Envrnmt.]
Select one of the three levels of initial print speed reduction at low temperatures.
126
Max. Value Min. Value
200 50
Max. Value Min. Value
4 1
Max. Value Min. Value
100 1
Step Unit
1 degree(s)
Step Unit
1 None
Step Unit
1 %