Kyocera 13600 Adjustment Manual page 123

Use this to reduce image quality degradation at the trailing edge of the paper.
Press [+] to increase the percentage and [−] to reduce it.
Setting Items
[Paper Transfer Current; Trail Edge]
33: [Paper Transfer Current; Trail Edge Dist]
Adjust the area at the trailing edge of the paper for application of paper transfer current.
Specify the length of area at the trailing edge of the paper to which the current set in 31: [Paper Transfer
Current; Trail Edge] is applied.
Use this to reduce image quality degradation at the trailing edge of the paper.
Press [+] to increase the length of area at the trailing edge to apply the current and [−] to reduce it.
Setting Items
[Paper Transfer Current; Trail Edge Dist]
34: [Avoid Ppr Trns Shck Jitr: Fed Intvl Adj]
Specify whether or not to enable the mode to reduce the jitter
transfer roller.
If [On] is selected, the machine adjusts the interval between sheets to reduce jitter. However, the
throughput may be reduced when you use paper larger than A4 or 8
[Off] to improve the throughput.
• Jitter does not occur with A4 , 8
Setting Items
[Avoid Ppr Trnsf Shock Jitter: Feed Interval Adj]
*1 The jitter occurs when the leading or trailing edge of paper that passes through the paper transfer unit is
transmitted to the drum unit via the intermediate transfer belt, causing banding.
35: [Paper Transfer Feed Speed Adjustment]
Adjust the transfer roller speed.
Max. Value
300
Max. Value
30
*1
1
/ × 14 or smaller paper.
2
[On]
[Off]
Min. Value Step
0 1
Min. Value Step
0 1
produced when paper enters the paper
1
/ × 14 . In such a case, select
2
Values
Setting Values
Unit
%
Unit
mm
121