Kyocera 13600 Adjustment Manual page 39

0207: [Adjust Fusing Temperature on Standby]
Adjust the set fusing temperature according to the machine status.
To achieve proper fusing when printing, the machine adjusts the temperature of the heating roller
according to the paper type or thickness. You can reduce the wait time during which the machine makes
this adjustment by changing the temperature in effect during standby.
In [Temperature on Standby Mode], specify the fusing temperature in standby mode (when the panel is
lit and the machine is ready for immediate operation).
In [Temperature on Low Power Mode], specify the fusing temperature in energy saver mode.
In [Temperature Before Performing a Process], you can specify the fusing temperature applied when the
machine is accessed from the control panel or when the machine is receiving print jobs.
Press [+] or [−] to adjust the temperature.
• Depending on the machine's other settings, changing this setting might increase the waiting time
before a process is performed.
Setting Items
[Temperature on 160 (13600)
Standby Mode]
155 (11100)
[Temperature on 75 (13600)
Low Power Mode]
160 (11100)
[Temperature 175 (13600)
Before Performing a
170 (11100)
Process]
0208: [Avoid Ppr Trnsf Shock Jitter: Feed Interval Adj]
Specify whether or not to enable the mode to reduce the jitter
transfer roller.
If "1" is selected, the machine adjusts the interval between sheets to reduce jitter. However, the
throughput may be reduced when you use paper larger than A4 or 8
this setting off to improve the throughput.
• Jitter does not occur with A4 , 8
Default Value
Value
1
/ × 14 or smaller paper.
2
Max. Min.
Value
200 0
*1
produced when paper enters the paper
1
/ × 14 . If this happens, turn
2
Setting Values
Step Unit
1 degree(s)
37