Epson AcuLaser C8500 Service Manual page 271

EPSON AcuLaser C8500
6. To stop printing, turn off the Dip-Switch(S1) on the MCU PWB if it is
present.
(A device stops after a print during the treatment is discharged.)
W A R N I N G
Make sure that your hand does not touch the other
elements when changing the Dip-Switch.
NOTE: The paper feed unit is in a position selected in (Section 2.7.3
"Paper Supply Unit Selection Control").
NOTE: The paper size is set in accordance with the [USIZESET]
command. (See Section 4.1 "Diagnostics by the Diagnostic
Commander").
When the printer is in an error status, printing operation cannot be
started.
NOTE: For information about the READY mode, see Section 2.6
"Operation Mode".
Chapter 4 Diagnostics
Figure 4-1. Test Print Procedure
Revision C
4-3