Front Snubber (Pl2.1.9) Removal - Epson AcuLaser C8500 Service Manual

EPSON AcuLaser C8500

3.2.6.2 FRONT SNUBBER (PL2.1.9) Removal

1. Remove the UNIVERSAL CASSETTE. (See Section 3.2.6.1.)
NOTE: In the following steps, be careful not to bend the edge of the FRONT
SNUBBER where paper is placed.
2. Remove 2 screws (black, tapped, 8mm) securing the FRONT GUIDE
ASSY and remove the FRONT GUIDE ASSY.
3. Using a tool such as pliers, release the hook securing the FRONT
SNUBBER SUPPORT and remove the SNUBBER SUPPORT. Then
remove the FRONT SNUBBER.
C H E C K
When installing the FRONT SNUBBER, be sure to align the
P O I N T
positioning hole of the FRONT SNUBBER with the rear pin.
(Never align it with the front one.)
Disassembly/Assembly/Adjustment Disassembly/Assembly Procedures
Figure 3-17. FRONT SNUBBER Removal
Revision C
3-21