Belt Cleaner Assy (Pl8.1.23) Removal - Epson AcuLaser C8500 Service Manual

EPSON AcuLaser C8500

3.2.11.3 BELT CLEANER ASSY (PL8.1.23) Removal

1. Remove the FUSER ASSY. (See Section 3.2.12.1.)
NOTE: Toner may spill from the BELT CLEANER ASSY while performing the
following. You should therefore spread paper on the frame below the
BELT CLEANER ASSY, and be careful not to spill toner while
performing the work.
NOTE: Be careful not to touch the IBT BELT ASSY or cleaning blade of the
BELT CLEANER ASSY. Do not allow the Cleaning Blade to come in
contact with any other parts.
NOTE: After removing the BELT CLEANER ASSY in the following procedure,
place it on paper in case toner is spilled.
2. Pull the shaft underneath the BELT CLEANER ASSY toward the rear,
undo the lock, and remove the BELT CLEANER ASSY by sliding the front
to the left.
C H E C K Accurately align the toner port of the AUGER HIGH ASSY
P O I N T
and toner discharge port of the BELT CLEANER ASSY
when mounting.
After replacing the BELT CLEANER ASSY with a new part,
C A U T I O N
enter the maintenance mode to reset the counter (IBT
Cleaner Clear). (For details, see Chapter 6.)
Disassembly/Assembly/Adjustment Disassembly/Assembly Procedures
2)
Figure 3-69. BELT CLEANER ASSY Removal
Revision C
3-63