Epson AcuLaser C8500 Service Manual page 175

EPSON AcuLaser C8500
8. Remove 2 screws (black, cup head, 8mm) securing the LOCK PLATE by
the right edge.
9. Remove 2 screws (black, cup head, 10 mm) securing the LOCK PLATE by
the left edge, and remove the LOCK PLATE.
10. Remove 2 screws (gold, tapped, 6 mm) securing the REAR GUIDE PLATE
L.
NOTE: In the following step, hold the REAR GUIDE while removing the
REAR GUIDE PLATE R. so that the REAR GUIDE will not drop.
11. Remove 1 screw (gold, tapped, 6 mm) securing the REAR GUIDE PLATE
R, and remove the REAR GUIDE PLATE R and the REAR GUIDE ASSY.
NOTE: In the following step, CASSETTE N/F SPRINGS will spring out.
Therefore, be careful not to lose them.
12. Moving the PLATE LINK, free the BOTTOM PLATE ASSY from the lock
and open it. Then slide the END GUIDE to the right and remove it.
C H E C K
When installing the SECTOR GEAR, make sure that the
P O I N T
triangle marks on the SECTOR GEAR and CASSETTE SIZE
ACTUATOR are aligned. Maker sure the END GUIDE is set
to the minimum paper size position.
Disassembly/Assembly/Adjustment
Figure 3-20. END GUIDE, SECTOR GEAR Removal - 3
Disassembly/Assembly Procedures
Revision C
3-23