Right Cover Assy (Pl1.1.51) Removal; Operation Panel (Pl1.1.60) Removal - Epson AcuLaser C8500 Service Manual

EPSON AcuLaser C8500

3.2.5.11 RIGHT COVER ASSY (PL1.1.51) Removal

1. Remove 3 screws (silver, knurled, 8mm) securing the RIGHT COVER
ASSY and open the front side of the cover. Then shift the cover to the rear
and remove it.
Figure 3-13. RIGHT COVER ASSY Removal
C H E C K
When installing the RIGHT COVER ASSY, fit the hooks in
P O I N T
the assembly in the positioning holes at the rear part of
the printer.
Disassembly/Assembly/Adjustment

3.2.5.12 OPERATION PANEL (PL1.1.60) Removal

NOTE: In the first step, the TOP COVER will remain connected to the printer.
Therefore, be careful not to move the cover too away from the printer.
1. Remove the TOP COVER along with the OPERATION PANEL. (See
Section 3.2.5.4.)
NOTE: In the following step, be careful not to break the hooks in the
OPERATION PANEL.
2. Using the 4 hooks in the OPERATION PANEL and remove the panel from
the TOP COVER ASSY by pulling it upward.
3. Disconnect the connector for the OPERATION PANEL (P/J317).
Disassembly/Assembly Procedures
Figure 3-14. OPERATION PANEL Removal
Revision C
3-18